16
2. Use the mounting bracket (optional) as a template for
marking the location of the mounting screws. Note: If there
are screws already holding the dashboard, you may be able to
use the same screw holes to mount the bracket.
3. Drill the necessary holes and secure the mounting bracket in
place using the screws provided.
CAUTION: Do not drill into air bags. Do not drill if what is
behind the dashboard is unknown.
4. Mount the scanner to the bracket only after the wiring has
been connected to the rear panel.
Permanently Connecting the Mobile Power Supply
CAUTION: If you are not experienced in connecting
accessories to the vehicle fuse box, please see your
automotive dealer for advice on proper installation.
1. Check the vehicle battery connections to determine which
battery terminal (positive or negative) is grounded to the
engine block or chassis. Most of today’s vehicles use a
negative ground. If your vehicle has a negative ground, follow
Steps 2 and 3. Otherwise, skip to the Caution in Step 3.
UB367ZV_UBC355CLT_1208.indd 16UB367ZV_UBC355CLT_1208.indd 16 2011/12/08 19:55:572011/12/08 19:55:57
To Next Page
Loading...
Need help?
General
