Unify OpenScape 35 G HFA - Individual phone configuration

Individual phone configuration 103
Individual phone configuration
Setting contrast
The display has four contrast levels that you can set according to your light
conditions.
Vol.+ or Vol.- Press one of the keys shown in idle mode.
Select and confirm the option shown.
Vol.+
or Vol.- Change the display contrast. Press the key repeatedly until the desired level is
obtained.
k Save.
Audio
Setting the ringer mode
You can use the two ringer mode options
• HiPath
• Local ringer
to decide how the ring tone is generated on the telephone. With the setting
"HiPath", the system sends the ring tone type and the dependent ring tone,
which you can adjust subsequently
Æ Page 104.
If "Local ringer" is selected, the system sends the ring tone type and you select
which ring tone is required for the respective ring tone type in the "Local ringers"
menu
Æ Page 106.
z
You can also configure the following setting via the web interface Æ Page 112.
Settings Open the menu
Æ Page 19.
Select and confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
or
Select and confirm the option shown.
Select and confirm the option shown.
Display contrast?
User ? f
Ringer ? f
Ringer mode ? f
HiPath? f
Local.ringer ? f
Option = Save & exit? f