More functions/services 75
Using system functions from outside
DISA (Direct Inward System Access)
If configured (consult your administrator), you can use an external phone like an
internal station to set up an outgoing external connection via the system. You
can also activate or deactivate the following system functions:
• Reset services and functions, code #0 Æ Page 74
• Call forwarding, code
*
1/#1 Æ Page 28
• Lock and unlock phone, code
*
66/#66 Æ Page 66
• Save your PIN code, code
*
93 Æ Page 67
• Send a message, code
*
68/#68 Æ Page 69
• Leave message/advisory message, code
*
69/#69 Æ Page 70
• Ringing group, code
*
81/#81 Æ Page 93
• Group call, code
*
85/#85 Æ Page 93
• Caller ID suppression, code
*
86/#86 Æ Page 64
• Camp-on tone, code
*
87/#87 Æ Page 47
• Open door, code
*
61 Æ Page 36
• Release door opener, code
*
89/#89 Æ Page 36
• Control relays, code
*
90/#90 Æ Page 78
• Do not disturb, code
*
97/#97 Æ Page 64
• Ringer cutoff, code
*
98/#98 Æ Page 63
• Dial using speed dial, code
*
7 Æ Page 42
• Associated service, code
*
83 Æ Page 74
Prerequisite: Your phone supports tone dialing (DTMF) or you can switch your
phone to tone dialing. The phone is not connected to the system.
j Establish a connection to the system. Enter the station number (consult your
administrator).
j Wait for the continuous tone (if necessary, switch phone to tone dialing) and
enter the internal number assigned to you and the corresponding PIN code.
# Enter the code (only required if programmed in the system).
j Wait for the dial tone and enter the code for example,
*
97 for Do not disturb on.
If necessary, make further entries; refer also to the user guide for dial pulse/
DTMF phones.
or
j Dial the external number.
You can only perform one function/establish one outgoing connection at a
time.
The connection is cleared as soon as the function is successfully
activated.
In the case of an external call, the connection is cleared as soon as one
of the call partners hangs up.
To Next Page
Loading...
