Unify OpenScape 35 G HFA - Line;trunk keys

Making calls in the team/executive/secretary configuration 87
Line/trunk keys
The programmable keys on multi-line phones function as line or trunk keys.
Every key programmed as a "Trunk key" (key label: Transfer Trk) corresponds
to one trunk with the result that you can configure up to eight trunks in
OpenScape Desk Phone IP 35 G.
As a team member, you can independently program the following functions on
keys
Æ Page 55:
• Direct station select
• Join/leave group
(not available on executive phone in an executive / secretary team)
• Ring transfer: On/Off
(only in an executive/secretary team)
You can also program a key with the function "Forward Line" (call forwarding) for
each line.
LED displays on trunk keys
Accepting calls with the trunk keys
Prerequisite: Your phone rings and/or a trunk key flashes quickly.
if nec.
T Press the trunk key that is flashing quickly.
(not necessary for automatic trunk seizure/prime line is not active).
^ Lift the handset.
or On-hook dialing: Speakerphone mode.
Dialing with trunk keys
if nec. S Press the free trunk key you wish to use to establish the connection
(not necessary for automatic trunk seizure/prime line is not active).
j Dial the phone number.
^ If the party answers: Lift the handset.
or On-hook dialing: Speakerphone mode.
LED Meaning
S
Off – The line is in idle mode.
T
Flashing
1
1 In this manual, flashing keys are identified by this icon, regardless of the flashing interval. The
flashing interval represents different statuses, which are described in detail in the corresponding
sections of the manual.
– Incoming call on the line.
– Hold reminder is activated.
– The line is on "Hold".
R
On – The line is busy.