18 Making calls
During a conversation
Handsfree mode
Activating/deactivating handsfree mode during a call and when establishing a connection:
¤ Press the handsfree key
Call volume
Muting the microphone
When the microphone is switched off, callers will no longer hear you.
Switch the microphone on/off during a call: Press .
Adjust the microphone sensitivity
Adjust the microphone sensitivity for the receiver or wired headset.
Set the acoustic profile to loud surroundings:
¤ Press and hold the button Use to set the sensitivity Save
Network services
Network services are dependent on the phone system and network provider.
Deactivating Calling Line Identification for the next call
By default for an outgoing call, the phone number is sent and can be shown with the caller on the display
(CLIP = CLI Presentation). When the caller's number is withheld, it is not shown on the called party’s display.
The call is made anonymously.
¤ . . . Use to select Select Services OK Next Call Anonym. OK . . . Use
to enter the number Dial . . . The connection is established without CLI
Call divert
When call divert is enabled, incoming calls are forwarded to another connection.
¤ . . . Use to select Select Services OK Call Divert OK Select when call
divert is to apply OK
Placing the handset in the charging cradle during a call:
¤ Press and hold down the handsfree key . . . Place the handset in the charging
cradle . . . hold for a further 2 seconds
Applies for the mode currently being used (handsfree, receiver or headset):
¤ Press . . . use to set the volume Save
The setting is automatically saved after around 3 seconds, even if Save is not pressed.
or: Briefly press the Profile key
¤ . . . Use to select Settings OK Audio Settings OK Mic
Sensitivity OK Use to select Earpiece / Corded headset Use to set the
sensitivity Save
To activate/deactivate the features, a code is sent to the telephone network.
All Calls: Calls are forwarded immediately.
No Answer: Calls are diverted if no one accepts the call within several rings.
When Busy: Calls are diverted if the line is busy.
Enable/disable: ¤ Status: . . . Use to select On or Off
Enter the number for call divert:
¤ To Phone Number . . . Use to enter the number
Enable: ¤ Send