First Step with HT682
Before first using the HT682, please ensure the battery is fully charged. There are three ways
to charge your HT682:
Docking Station
USB/Charging cable
Rechargeable Lithium-Ion battery pack
NOTE: Data loss may occur if the HT682's backup battery is not adequately charged. Before
charging the main battery, make sure the backup battery switch is ON.
Install the Battery Pack
1. Remove the battery cover.
2. Move the backup battery switch to the ON position (see the description below).
3. Insert the battery pack so that the contacts on the battery pack line up with the contacts in
the battery compartment. Fully seat the battery.
7
To Next Page
Loading...
