Unitech MS652 - Timeout between Decodes, Different Symbols

- 132 - © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS652 User’s Manual
4.16 Timeout Between Decodes,
Different Symbols
Use this option in presentation mode or Continuous Bar Code Read to
control the time the engine waits before decoding a different symbol. It is
programmable in 0.1 second increments from 0.1 to 9.9 seconds. The
default is 0.1 seconds.To select the timeout between decodes for different
symbols, scan the following bar code, and then scan two bar codes from
Appendix B, Numeric Bar Codes that correspond to the desired interval,
in 0.1 second increments.
Timeout Between Decodes, Different Symbols