Unitech MS652 - Inverse 1 D

-80- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS652 User’s Manual
3.12 Inverse 1D
Scan one of the following bar codes to set the 1D inverse decoder setting:
•Regular Only - The engine decodes regular 1D bar codes only
•Inverse Only - The engine decodes inverse 1D bar codes only
•Inverse Autodetect - The engine decodes both regular and inverse 1D
barcodes.
Note: This parameter does not apply to GS1 DataBar code types
The Inverse 1D setting may impact Composite or Inverse Composite decoding. See
Composite Inverse.
Regular*
Inverse Only
Inverse Autodetect