-29- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS652 User’s Manual
3.2.19 Convert UPC-E to UPC-A
Enable this to convert UPC-E (zero suppressed) decoded data to UPC-A
format before transmission. After conversion, the data follows UPC-A
format and is affected by UPC-A programming selections (e.g., Preamble,
Check Digit).
Disable this to transmit UPC-E decoded data as UPC-E data, without
conversion.
Convert UPC-E to UPC-A (Enable)
Do Not Convert UPC-E to UPC-A (Disable)*
3.2.20 Convert UPC-E1 to UPC-A
Scan Convert UPC-E1 to UPC-A (Enable) to convert UPC-E1 decoded
data to UPC-A format before transmission. After conversion, the data
follows UPC-A format and is affected by UPC-A programming selections
(e.g., Preamble, Check Digit).Scan Do Not Convert UPC-E1 to UPC-A
(Disable) to transmit UPC-E1 decoded data as UPC-E1 data, without
conversion.
Convert UPC-E1 to UPC-A (Enable)
Do Not Convert UPC-E1 to UPC-A (Disable)*
To Next Page
Loading...
