Unitech MS912+ - 2.6.11 GS Character Replacement

21
© 2022 Unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.
All product and company names are trademarks, service marks, or registered trademarks of their respective owners
EA520 User’s Manual
MS912+ 2D User’s Manual
2.6.11 GS Character Replacement
Enable GS Character Replacement
Disable GS Character Replacement *
Define Replacement Character
Note:
1. When enabled, the <GS> character in all barcodes will be replaced by
the one defined by the user.
2. To define replacement character, please refer to below:
Example: Set Replacement Character as “X”
Step1: Scan “Define Replacement Character”
Step2: Scan “X” in Appendix – Upper Case Alphabets
Step3: Scan “Define Replacement Character”