UAD Powered Plug-Ins Manual - 130 - Chapter 11: UAD-2 Satellite
Satellite System
Requirements
To use UAD-2 Satellite, your system must meet the minimum system require-
ments for UAD Powered Plug-Ins in addition to the UAD-2 Satellite prod-
uct-specific requirements below.
UAD-2 Satellite requires the following hardware and software:
• Mac OS 10.6 Snow Leopard (Intel systems only)
• UAD Powered Plug-ins software v5.8.1 or higher (included)
• Available FireWire 800 or FireWire 400 interface port
• See “System Requirements” on page 26 for additional requirements
UAD-2 Satellite Installation
Install Software
First
The software installation procedure for UAD-2 Satellite is the exact same pro-
cedure as those for UAD cards. Install the software before the hardware un-
less you are updating a previous installation. Refer to “UAD Software Instal-
lation” on page 28 for detailed procedures.
Software
Updates
The CD-ROM in the retail package may not contain the latest UAD software.
Please check our website for software updates:
• http://www.uaudio.com/support/uad/downloads.html
If the UAD software is already installed, the UAD Meter & Control Panel has
a convenient button that links to the updates page (“Check for Updates” on
page 65).
Satellite Install
Location
When selecting a location to position UAD-2 Satellite during installation and
use, consider these points:
• The unit should be positioned on a secure, stable surface and not moved
during operation. This will help prevent the disruption of signals from cables
and/or connectors if they are accidentally bumped (or worse).
• For proper ventilation to prevent overheating, place UAD-2 Satellite on a
hard, flat sur
face and do not cover the unit. Allow air to circulate under-
neath the chassis. Multiple UAD-2 Satellite units may be safely stacked.
• High levels of radio-frequency radiation could interfere with proper opera-
tion. If possible, avoid placement near unshielded monitors, radio transmit-
ters, and similar equipment.
To Next Page
Loading...
