UAD Powered Plug-Ins Manual - 368 - Chapter 36: Neve 33609 Compressor
Neve 33609 Screenshot
Operation
The UAD Neve 33609 is a two-channel device capable of running in stereo
or dual-mono modes. The active mode is determined by the mono/stereo
switch (see “Mono/Stereo” on page 372). When the 33609 is used in a
mono-in/mono-out configuration, the channel 2 controls are disabled.
Each channel consists of a compressor and a limiter. Each of these functions
has its own separate group of controls. Since the controls for each of the two
channels are identical, they are detailed only once.
Note: For a detailed explanation on how compressors and limiters operate,
see “Compressor Basics” on page 281.
Signal Flow In the 33609, the output of the compressor is fed to the input of the limiter.
Like the original hardware, the signal does not flow “from the left to the right”
of the interface. Understanding this signal flow will help you obtain a more
predictable result (see Figure 121 below).
Modeling The UAD Neve 33609 models all aspects of the original 33609 hardware,
including the desirable harmonic distortion characteristics. These qualities are
more prominent at higher input levels (see “Headroom” on page 373” for
more info).
When the compressor and limiter are both disabled, some (good) coloration
of the signal occurs, just like the hardware. If a true bypass is desired, use the
power switch (“Power” on page 375) to disable the plug-in.
Figure 120. The Neve 33609 plug-in window
Figure 121. Signal flow within UAD Neve 33609
Output
Input
Compressor
Limiter
Compressor
Gain
Output
Gain
To Next Page
Loading...
Need help?
General
