UAD Powered Plug-Ins Manual - 468 - Chapter 46: Precision Multiband
EQ Display
In the EQ Display, the entire audio spectrum from 20 Hz to 20 kHz is dis-
played along the horizontal axis. Gain and attenuation of the five band fre-
quencies (up to ±12 dB) are displayed along the vertical axis.
Band Curves The Band Curves show the relative frequency and gain settings of the bands.
The sides of the colored curves are a representation of each band’s frequency
settings, and the top of each curve represents the band’s gain setting.
Note: The currently selected band is displayed with a thicker bold line. Dis-
abled bands (see “Band Enable & Solo” on page 467) are displayed with a
thinner line.
EQ Response The EQ Display also shows the processed EQ response dynamically as a light
blue line across all bands (if the Dynamic EQ display option is enabled; see
“EQ Display Switch” on page 473).
Curve Control
Points
Band gain, center frequencies (cF), crossover frequencies (xF), and band-
width can be modified by manipulating the colored band curves in the EQ
Display with the cursor.
When the cursor is moved over the pre-defined “hot spots” in the EQ Display,
the cursor changes shape to indicate that adjustments can be made. Each of
these control points and their corresponding available adjustments are de-
tailed below.
Figure 149. Precision Multiband EQ Display
To Next Page
Loading...
Need help?
General
