UAD Powered Plug-Ins Manual - 136 - Chapter 11: UAD-2 Satellite
• Although “Hot Plugging” on page 134 is supported, disconnecting UAD-2
Satellite when UAD plug-ins are running could cause unpredictable behav-
ior. Quit all UAD hosts and the UAD Meter & Control Panel before discon-
necting or powering down UAD-2 Satellite.
Important: Do not disconnect UAD-2 Satellite while UAD plug-ins are
loaded.
• Once the host software is quit, you may connect or disconnect the unit even
if the host computer and/or UAD-2 Satellite is powered on (see “Hot Plug-
ging” on page 134).
• Connect all FireWire devices to the bus before activating UAD plug-ins. See
“Adding a device to the active bus” on page 134 for details.
• As of UAD v5.9.0 (and higher), two UAD-2 Satellites can be used together
in a single system. See Chapter
5, “Using Multiple UAD Devices” for addi-
tional information.
• Select a suitable location for the unit. See “Satellite Install Location” on
page 130. UAD-2 Satellite units may be safely stacked.
• Do not bend sharp angles into or otherwise kink the FireWire cable. The ca-
ble can be damaged by improper handling.
• UAD-2 Satellite contains no user serviceable parts. Opening the unit will
void the warranty
.
Power Supply • UAD-2 Satellite requires external DC power. It ships with an external power
supply adapter that converts AC power to 12VDC @ 1.25A. AC input into
the adapter can be 100V–240V at 50–60 Hz; several AC plug adapters
are provided for international use.
• The power supply DC output connector is ring=ground/negative and
tip=hot/positive. UAD-2 Satellite is diode-protected; the unit will not be
damaged if the wrong DC polarity (or AC input) is connected.
• The Quad Satellite draws a maximum of 7 watts; the Duo draws 4 watts.
• The acceptable range of power input for UAD-2 Satellite is 9VDC – 15VDC
@ 1A (9 W
atts minimum).
Note: UAD-2 Satellite requires the external power supply. It cannot be
powered by the FireWire bus, nor can it supply bus power to other FireWire
devices.
To Next Page
Loading...
