UAD Powered Plug-Ins Manual - 401 - Chapter 38: Nigel
Bright Button Increases the brightness of the Amp model. Bright is on when the button glows
bright red.
Amp On/Off
Button
Enables or disables the Amp module within Preflex. The Amp is engaged
when the button indicator is bright red. You can use this switch to compare the
Amp settings to the original signal or bypass the entire Amp section to reduce
UAD DSP load.
Amp Type Menus The Amp Type pull down menus establish the overall sound and response of
Preflex and also determine the function and ranges of the Amp knobs. Two
amp types (A and B) can be active simultaneously by positioning the Morph
control between them.
Note: For the following descriptions of the Amp models and other references
that you may find throughout this manual, please be aware that Fender, Mar-
shall, Mesa, Matchless, Aiken, and any other manufacturer, model name, de-
scription, and designations are all trademarks of their respective owners,
which are in no way associated or affiliated with Universal Audio. These
trademarks and names are used solely for the purpose of describing certain
timbres produced using Universal Audio’s exclusive modeling technology.
Amp Type List
and Descriptions
Table 26. Amp Type List and Descriptions
AMP TYPE DESCRIPTION
Rectifried Modern super-high gain amplifiers
Marsha Emulations from range of new and old Marshall amps
Bassmon Fender Bassman and similar amplifiers
Boutique Matchless, Aiken, and other high-end tube amplifiers
Custom Blues Designed to achieve those hard-to-nail blues tones. Lower gain.
Supa Clean Direct input into a channel strip
Super Sat Extremely high gain amp, breaks up easily in low end
Gemini Fender Twin and similar clean tube amplifiers
Big Beaver Distortion pedal stomp-box emulations
Super Custom Higher-gain and more power than Custom Blues
Big Bottom Optimized for bass guitar
Super Tweed
Small Fender Champ and Princeton when cranked up loud
To Next Page
Loading...
Need help?
General
