Universal Audio UAD User Manual

UAD Powered Plug-Ins Manual - 418 - Chapter 38: Nigel
Mod Delay LFO
Type Table
Mode Menu The Mode menu reconfigures the settings of the Mod Delay controls. Addition-
ally, the function and label of the second and third controls in the Mod Delay
module are determined by the Mode menu.
When the Mod Delay Mode is set to Flanger, the second and third knobs are
labeled Sweep Lo and Sweep Hi respectively. When the Mod Delay Mode is
set to Chorus or Vibrato, the second and third knobs are labeled Depth and
Time respectively.
In all modes except Flanger, the function and sound of the controls are iden-
tical; only the settings are different. Similarly, in Flanger 1 and 2 modes, the
function and sound of the controls are identical; only the settings are different.
Mod Delay
On/Off Button
Enables or disables the Mod Delay.You can use this switch to compare the
Mod Delay settings to that of the original signal or bypass the Mod Delay to
reduce UAD DSP load.
Table 32. Mod Delay LFO Types and Descriptions
Sin 0 In-phase sine wave
Sin 90 Sine wave 90 degrees out of phase
Sin 180 Sine wave 180 degrees out of phase
Tri 0 In-phase triangle wave
Tri 90 Sine wave 90 degrees out of phase
Tri 180 Sine wave 180 degrees out of phase
Trem Up The Trem/Fade module is used as the LFO source. On a stereo signal,
both channels ascend in pitch in synchronization with the Trem/Fade
amplitude ramp.
Trem Down The Trem/Fade module is used as the LFO source. On a stereo signal,
both channels descend in pitch in synchronization with the Trem/Fade
amplitude ramp.
Trem U/D The Trem/Fade module is used as the LFO source. On a stereo signal,
the left channel ascends in pitch as the right channel descends in
synchronization with the Trem/Fade amplitude ramp.
Trem D/U
The Trem/Fade module is used as the LFO source. On a stereo signal,
the right channel descends in pitch as the left channel ascends in pitch
in synchronization with the Trem/Fade amplitude ramp.
Table 33. Mod Delay Mode Menu List
Chorus 1 Flanger 1 Vibrato 2
Chorus 2 Flanger 2 Comb Filter 1
Quad Chorus Vibrato 1
Comb Filter 2

Universal Audio UAD Specifications

General

Operating System	macOS, Windows
Sample Rate Support	Up to 192 kHz
Category	Audio Processing
Format	VST, AU, AAX
DSP Processing	Yes
Plug-ins Included	Varies by bundle (e.g., Analog Classics, Lexicon, etc.)
Hardware Required	Universal Audio DSP Accelerator (e.g., Apollo, Satellite)