Page 31
LPH800 TREATER
ADJUSTING THE SEED FLOW GATE
When the black lever is pulled
down, the seed gate is in the
closed position, and will not
allow seed to flow through
Below are pictures that illustrate how to open, close, and adjust the opening of the
seed flow gate.
When the black lever is pushed
up, the seed gate is in the open
position, and seed will flow
through
Regulate the amount of seed
flowing through the seed treater
by using the spring-loaded
coupler and moving it to a
different notch. The more notch-
es exposed, the higher the
seed flow.
If the seed treater is equipped with a seed wheel, the adjustable
seed flow gate should always be left in the most wide open position.
If the seed gate is not open fully, seed flow will be diminished and
may even cause seed to back up into the seed wheel.
NOTICE
To Next Page
Loading...
