Page 46
LPH800 TREATER
When storing the LPH800 series seed treater for long periods of time, the following
procedure must be followed to reduce the chance of rust, corrosion and fatigue of the
treater. You can also use these steps when storing the machine for the winter.
SUPPLY HOPPER
1. Clean out the supply hopper of any debris (compressed air can be used).
2. Wipe the proximity switches clean.
3. Tarp or cover the hopper to keep out any unwanted pests.
Storage
Section
H
A dust mask and protective rubber gloves shall be used when
cleaning the machine.
ATOMIZER CHAMBER
1. Remove and clean the atomizer
housing.
2. Remove the atomizer head and
stainless steel plumbing. The
atomizer head can be disassembled
(right), for easier cleaning. It is
threaded together and can simply be
unscrewed.
3. Reinstall the atomizer head and
plumbing. Grease the bearing and
spin the atomizer head a few times
to ensure all grease has been worked
into the bearings.
To Next Page
Loading...
