Page 44
LPH800 TREATER
ATOMIZER
To access inside of atomizer housing, push up on the quick release handle and slide
back the atomizer (below).
Quick-Release
Handle
Slide back atomizer housing and grease
bearing inside. Bearing needs just one
pump of grease every 40 hours of use
(right).
Clean any build-up inside the housing and
the atomizer head. To remove the
atomizer head, loosen the set screw
located on the bottom of the head.
Check for any play in the atomizer shaft.
Make sure the atomizer spins smoothly.
Ensure the adjustable chute is fitting
completely into the drum opening.
Adjust if necessary.
Atomizer Head
Set Screw Bearing
To Next Page
Loading...
