12
Connecting the cutter to a computer
Attach the power cord to the cutter and then
plug in the unit and turn on the power.
If using the Serial Cable to connect
your cutter to a computer:
If using the USB Cable to connect
your cutter to a computer:
If you are using a Serial Cable to connect your cutter to a computer then
no further setup is necessary. Simply connect one end of the cable to
the cutter and the other end to a computer and setup is complete. If
you have more than one serial connection on your computer or you are
experiencing communication issues between your cutter and computer
then you may wish to verify that the correct COM port is being used in
your software setup, but for most users the COM port will be COM1.
You will need to download and install drivers for the USB connection to
work properly. Go to www.uscuttersupport.com and select the driver that
supports your Windows version.
INSTALLING VINYL MASTER SOFTWARE
Your Vinyl Cutter comes bundled with VinylMaster Cut
software, an easy to use software with the tools to help
you take your projects from concept to a ready to cut
computer image file.
You can download and install the VinylMaster Cut
software at www.uscutter.com/download, and you will
need the key code packaged with this cutter to activate
the software. You may need to download drivers to
support your operating system. Drivers are available at
http://support.uscutter.com
Training for VinylMaster is all done via short videos
accessed through the software. To access the videos,
click on the SUPPORT link in VinylMaster, then further on
HELP TOPICS.
To Next Page
Loading...
Need help?
General
