UVD Robot Model B - User manual v2.1
Battery warning!
● Never use a damaged charger or battery. The battery used in this product may present
a risk of fire or chemical burn if mistreated. Batteries may explode if damaged.
● Only recharge your battery with the provided approved chargers designated for this
product. Use of other batteries may present a risk of fire or explosion and the warranty
will be terminated.
● The battery in your product cannot be removed or replaced by the user, any attempt to
do so is risky and may result in product damage. Contact your distributor / technical
service to replace the battery.
● Dispose the batteries according to local regulations. Do not dispose of as household
waste or in a fire as they may explode.
Charger warning!
● Always use the original charger. The use of any other chargers may damage or
destroy the product and could be dangerous. Never use a charger that is damaged.
The use of other chargers will invalidate any warranty.
● When you disconnect the power cord, grasp the plug and pull the metal pin towards
you, twist counterclockwise and pull the plug, not the cord.
● Do not attempt to disassemble the charger as it may expose you to dangerous electric
shock. Incorrect reassembly can cause electric shock or fire when the product is
subsequently used.
● Avoid charging your product in extremely high or low temperatures and do not use the
charger outdoors or in damp areas.
Electrical warning!
● To avoid the risk of electric shock, do not remove the cover (or back) or try to access
any internal parts.
● Always store and use the robot away from water.
● The charger must be connected to the power mains and grounded in compliance with
the effective standards and regulations.
● Do not touch the power cord or any other connected cables with wet hands.
● In case of robot failure or tablet damage refer servicing to your local distributor.
Collisions warning!
To avoid the risk of collisions, slips, trips and falls that can cause serious injuries:
● Remove hazardous objects from robot path.
● When using the robot in manual mode, drive responsibly and keep the robot away
from edges and obstacles. Avoid driving the robot onto holes, stairways, escalators,
into open elevator shafts or any area where there is a significant drop in elevation as
serious damage may result if the robot falls down. It is the operator’s responsibility to
drive carefully and avoid contact with obstacles and individuals as the robot is not
designed to avoid them in manual mode.
● Avoid inclinations above 5% as the robot could enter an uncontrollable slip. When in
ramps or inclined surfaces, avoid sudden stops and use low speed down ramps.
● Ensure the maps in the app are up to date to avoid risk of collisions when running in
autonomous mode.
6
To Next Page
Loading...
Need help?
General