UVD Robot Model B - User manual v2.1
This equipment is intended for indoors use only.
Do not leave the robot unattended where it can be accessed by others. Ensure that third
parties, particularly children, elderly people and patients, are not endangered when operating
the robot.
Avoid excessively humid environment
Risk of damage to robot or robot components.
Ambient humidity in the robot environment must be within a reasonable level (see operational
conditions in section 4.4).
Use only on dry and even surfaces
Danger of personal injury and / or damage to robots if surfaces are wet or slippery as the
robot could enter an uncontrollable slip.
Remove obstacles on the floor before operating the robot
Risk of damage to the robot as their sensors cannot detect objects lower than 5 cm of height
and may run over them. Remove any wires on the floor to prevent the robot from tangling with
the wires and fall down.
Manual handling caution!
During transport or other operations which require to manually move the robot, ensure that it
is always kept in the vertical position. Handling should be done at least by two people, using
appropriate safe manual handling techniques and precautions to reduce the risk of injury.
Never handle the robot by grabbing the UV tower.
UV lamps caution!
● UV lamps reach high temperatures during normal operation and can cause severe
burns. Let the lamp cool for at least 10 minutes. Never touch the lamps.
● Avoid touching or scratching the glass section of the lamp. Fingerprints weaken the
lamp envelope, and this may lead to lamp breakage.
● Do not operate the robot if any of the lamps are damaged and contact technical
service for support.
● If a lamp breaks there is a risk of personal injury and mercury vapors can be released
and pose a health hazard. In case of breakage, ventilate the room for 30 minutes and
then collect the broken parts using cut-resistant gloves, a broom and dustpan, never
use a vacuum cleaner. Put them in a seal container and dispose of them in compliance
with national regulations.
Maintenance caution!
● Unplug the charger before cleaning.
● The cord and charger may only be dry-dusted.
7
To Next Page
Loading...
Need help?
General