Uwatec MANTIS - Selecting the Salt (Sea) or Fresh Water; Apnea Settings; Setting the Apnea Session Total Depth

28
MANTIS USER MANUAL
buttons. By pressing the SEL button the
unit settings will be confirmed.
4.3.5 Selecting the salt (sea) or
fresh water
MANTIS determines the depth by
measuring pressure using water density as
a constant. 10m/33ft depth in salt water
corresponds to approximately 10.3m/34ft
in fresh water.
F
NOTE: This setting will adjust the depth
on all modes: SCUBA, GAUGE and
APNEA.
By pressing the SEL button in this menu the
salt water on/off setting on the bottom row
of the display starts blinking. You may scroll
between these two settings by pressing the
+/UP or -/DOWN button and confirm your
selection by pressing the SEL button.
4.4 Apnea settings
Apnea diving related selections are grouped
in this menu.
By pressing the SEL button the following
menu’s can be accessed.
TOTAL SESSION
DEPTH
SIF
DUAL DEPTH
ALARM
DEPTH INCREMENTAL
ALARM
DEPTH TIME INTERVAL
ALARM
SURFACE INTERVAL
ALARM
LOW HR ALARM
ASCENT SPEED
ALARM
APNEA SET
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
SEL
UP
UP
UP
UP
UP
UP
UP
UP
4.4.1 Setting the apnea session
total depth