Uwatec MANTIS User Manual

30
MANTIS USER MANUAL
depth alarm may be set from 5 to 100
meters. By pressing the SEL button the on/
off selection starts blinking. By pressing the
+/UP or -/DOWN button this can be edited
and then confirmed by pressing the SEL
button.
F
NOTE: The rst alarm is short in
sequence to get your attention, and
then the second alarm is continuous.
By setting the rst alarm deeper than
the second, it will be masked by the
continuous alarm and you will not be
able to hear the rst one.
4.4.4 Setting the depth
incremental alarm
By pressing the SEL button in this menu
the alarm depth starts blinking. By pressing
the +/UP or -/DOWN buttons you may
select the alarm value from 5 to 100 meters
(20..330 feet). By pressing the SEL button
the incremental mode starts blinking. By
pressing the +/UP or -/DOWN the you may
scroll between the direction of the alarm or
disable it with selections: off, dn (down), up
or both. By pressing the SEL button the
settings will be confirmed.
4.4.5 Setting the dive time interval
alarm
By pressing the SEL button at this menu
the time starts blinking and by pressing the
+/UP or -/DOWN you can select the interval
from 15 seconds up to 10 minutes. By
pressing the SEL button the function starts
blinking and you may enable or disable it by
choosing on/off by pressing the +/UP or -/
DOWN buttons. By pressing the SEL again
the settings will be confirmed.
4.4.6 Setting the surface interval
alarm
By pressing the SEL button in this menu
the surface interval time starts blinking. By
pressing the +/UP or -/DOWN buttons you
can select the interval from 15 seconds up to
10 minutes. By pressing the SEL button the
function starts blinking and you may enable
or disable the alarm by selecting on/off with
the +/UP or -/DOWN buttons. By pressing
SEL again the settings will be confirmed.

Uwatec MANTIS Specifications

General

Brand	Uwatec
Model	MANTIS
Category	Diving Instrument
Language	English