WARNING
- A leaking battery cap may lead to the destruction
of MANTIS by water seeping in or cause MANTIS
to switch off without prior notice.
- Always open the battery compartment in a dry
and clean environment.
Dry MANTIS with a soft towel.
Unscrew the battery cap with a tool.
Replace the main O-ring (replacement
O-rings are available from your authorized
SCUBAPRO UWATEC dealer).
Remove the isolation sticker.
Open the battery latch with tweezers.
Remove the empty battery and recycle it in
environmentally friendly way.
Insert the new battery with “+” side on top.
Close the battery latch.
Attach the isolation sticker.
Screw the battery cap back in place.
Check the MANTIS functions and housing
sealing.
WARNING
We recommend having the MANTIS battery
replaced by an Authorized SCUBAPRO dealer.
The change must be made with particular care
in order to prevent water from seeping in. The
warranty does not cover damages due to an
improper placement of the battery or incorrect
closing of the battery cap.
MANTIS stores the tissue saturation
information in a non-volatile memory, so
the battery can be replaced at any time
between dives without loss of information.
F
NOTE: After a dive, while on the
surface, MANTIS stores tissue
desaturation data once every hour
until desaturation is complete. If a
battery is changed while MANTIS has
remaining desaturation time, the tissue
data will not be lost, but MANTIS will
reference the last stored data set. As
a consequence, the data displayed on
the surface screen after the battery
change (desaturation time, surface
interval, no-fly time and CNS O
2
) may
be different from the values displayed
just prior to battery removal.
After replacing the battery, you must set the
date and time.
The O-ring must be replaced each time the
MANTIS is opened.
The battery case must be completely
closed.
7.4 Warranty
MANTIS has a two-year warranty covering
defects in workmanship and functioning.
The warranty only covers dive computers,
which have been bought from an
authorized SCUBAPRO dealer. Repairs or
replacements during the warranty period
do not extend the warranty period itself.
Excluded from warranty coverage are faults
or defects due to:
- excessive wear and tear
- exterior influences, e.g. transport
damage, damage due to bumping and
hitting, influences of weather or other
natural phenomena
- servicing, repairs or the opening of
the dive computer by anybody not
authorized to do so by the manufacturer
- pressure tests which do not take place in
water
- diving accidents
- improper placement of the battery cap.
For European Union markets, the warranty
of this product is governed by European
legislation in force in each EU member state.
All warranty claims must be returned with
dated proof-of-purchase to an Authorized
SCUBAPRO Dealer. Visit www.scubapro.com
for the dealer nearest you.
To Next Page
Loading...
Need help?
General
