Uwatec Smart PRO - Terminology; Display During Microbubble (MB) No-Stop Phase; Display During Level-Stop Phase

23
2 Terminology
IV Uwatec
®
Smart dive computers
English
IV
This chapter will exclusively deal with terminology and display features used whilst diving with MB-levels.
All other features are described in chapter III (page 11).
2.1 Display during Microbubble (MB) No-Stop Phase
dive time MB No-Stop time
12min
current depth
maximum depth
26.2 m/86ft
Level-stop phase
MB No-stop phase
Dive phase during which ascent is allowed
without MB level- stop.
time
depth
DIVE TIME
DEPTH
DECO INFO
MAX.DEPTH
CNS O
2
%
NO STOP
%
%
C
An MB-level
between
L1 and L5
was chosen.
MB No-Stop time
Remaining time at a
respective depth allowing
ascent without level-stop.
2.2 Display during Level-stop phase
lowest
level-stop
Total ascent time (14 min)
3 min
level-stop
9m/30ft
35.7m
117ft
6m/20ft
3m/10ft
Level-stop phase
To complete the dive without being
reduced to a lower MB level all
requested level-stops must be
observed.
MB No-stop phase
Time
Depth
DIVE TIME
DEPTH
DECO INFO
MAX.DEPTH
CNS O
2
%
m
LEVELSTOP
%
%
C
Level-stop time
The duration of a level-stop
at a given level-stop depth
will be displayed.
Level-stop depth
The deepest Level-stop
at the time will be
displayed.
Total ascent time
including Level-stops
ft
Eg-SMART III+IV 13.10.2001 11:16 Uhr Seite 23