EasyManuals Logo

Uwatec Smart PRO User Manual

Uwatec Smart PRO
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
24
3 Preparation for a dive with Microbubble-Levels (MB-levels)
IV Uwatec
®
Smart dive computers
3.1 Setting the MB-level
To change the MB-level Smart must be in user-mode.
1. Bridge contacts B and + until the symbol for MB-levels appears.
2.
Confirm that you wish to change the displayed MB-level by bridging B and E.
3. Change MB-level by bridging contacts B and + or B and - .
4. Confirmation with B and E the selected MB-level.
Without confirmation the display will disappear after 3 minutes and your
entries will not be accepted.
Smart will display the symbol to confirm that an MB level beyond L0 (L1-
L5) has been chosen. During the dive the MB-level itself will only be shown if a
level-stop has been ignored (see p. 28).
MB-Levels do have an influence on your dive planner, your desaturation and
no-flight time. They can also alter the range of altitudes a dive can safely carry
out.
4 Functions during the Dive with Microbubble-Levels
4.1 Level-stop information
Microbubble (MB) No-Stop Time
While diving with MB-levels L1 to L5 Smart will display the MB no-stop time instead of the ordinary no-
stop time. Within the MB no-stop time no level-stops are required.
The arrow and the MB-level symbol are visible. The remaining MB no-stop time is shown
in minutes.
Information and alarms for MB no-stop time and ordinary no-
stop time are the same (see p. 18).
In spite of the MB-level program, we generally recommend to
perform a slow ascent during the last few metres / feet.
Level-stop
On entering the level-stop phase, the arrow disappears and the
arrow
appears. The arrow flashes for 8 seconds and an acou-
stic alarm is initiated. To complete the dive without being reduced to a deeper
MB-level, all requested level-stops must be observed.
To the right of the arrow, the deepest level-stop is displayed in met-
res/feet. The display <3m 2:> (<10ft 2:>) means that a level-stop of 2 minutes
at a depth of 3 metres (10ft) has to be made.
When a level-stop has been finished, the next higher level-stop if necessary
is displayed. When all level-stops have been made, the arrow extin-
guishes and the arrow reappears. The indication of time on the
lower right shows the MB no-stop time again.
NO STOP
LEVELSTOP
LEVELSTOP
LEVELSTOP
LEVELSTOP
NO STOP
NO STOP
DIVE TIME
DEPTH
DECO INFO
MAX.DEPTH
NO STOP
%
C
MB no-stop time
DIVE TIME
DIVE TIME
+
DIVE TIME
DEPTH
DECO INFO
MAX.DEPTH
CNS O
2
%
m
LEVELSTOP
%
%
C
Eg-SMART III+IV 13.10.2001 11:16 Uhr Seite 24

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uwatec Smart PRO and is the answer not in the manual?

Uwatec Smart PRO Specifications

General IconGeneral
BrandUwatec
ModelSmart PRO
CategoryDiving Instrument
LanguageEnglish

Related product manuals