51
Removal of the high pressure lamp modules
To avoid damaging or scratching the bench
sheet, cover the bench sheet if it has not yet
been removed. Removal of the bench sheet.
Removal of the cantilever arm’s top paneling
• Remove the screws (40/1) of the cantilever arm’s
paneling (40/2) on the left and right
• Remove the cantilever arm’s top paneling (41/1)
• Disconnect control lead X35 (41/2) LED-illumination on
cantilever arm.
• Remove the cantilever arm’s cover screws 41/1)
• Push through control lead X35 (42/2) for LED-illumination
Control lead X35 (43/1) for LED-illumination
on cantilever arm
To Next Page
Loading...
