V-TEK DigiOpen 2Easy DMR18S - Unlock Code Management; Clock and Date Settings; Setup Code Entry; Card Management Functions

2 EASY
Input 0
Input 0
Input time
4.Unlock Code: Type-in 4 to enter Unlock Code setting.
Default unlocking code is 1111. Type-in 4 digit numbers to set a
new code (Exception numbers: 8001~8019 and 9008)
6.Clock: Type-in 6 to enter Clock setting
5.Work Mode: Type-in 5 to enter Work Mode setting. Four
modes are available,the setting range is 0~3.(More details refer to the
following Work Mode section)
0 : 32 apartments
1 : 128 apartments
2 : Router
3: Gateway
* Cancel # Save
(***)
[ - - - ]
4. Unlock Code [1111]
* Cancel # Save
[ - ]
6. Clock ...
0: DD/MM/YY
1: MM/DD/YY
* Cancel # Save
[ - ]
6. Clock ...
0: 24-Hour
1: 12-Hour
--/--/-- -
--/--
* Cancel # Save
DD/MM/YY W HH/MM
6. Clock ...
* Cancel # Save
DD/MM/YY W HH/MM
6. Clock ...
16/07/15 4
14/13
* Cancel # Save
(0~3)
[ - ]
5. Work Mode [0]
7.Setup Code: Type-in 7 to enter Setup Code setting. Input 8 digits
to set a new setup code, then press ‘#’ to save
8.About: Type-in 8 to enter About page. The information includes
Hardware version, Software Version etc.
9.Default: Type-in 9 to enter Default setting. Input setup code to
restore to a factory default
1.Add Card: Type-in 1 to enter Add Card setting
* Cancel # Save
(********)
[ - - - - - - - -]
7. Setup Code ...
* Cancel # Save
Hardware Version
DMR18S-CT a1.1
Software Version
V000101
Manufacture Date
Dailing Count[0006]
Calling Count[0002]
Unlock Count[0005]
2015-06-22
* Cancel # Save
Please input password
[ - - - - - - - - ]
9. Default ...
CARD MANAGEMENT
In debug mode, type-in
1# to enter Tools
Type-in 3 to enter
Card Manage
Card Manage page
overview
Pres NO.
to select
*Back
Tools
Press No.
to select
*Back
1.Installer Setup
2.Setup
3.Card Manage
4.Online Monitors
5.Online Devices
6.Voltage Measure
1. Add Card ...
2. Delete By Card
3. Delete By M.code
4. Cards Information
5. Format
>> Debug State <<
0-# Redial
1-# Tools
2-# Exits
Card
Memory
Show the card
* Cancel # Save
Please input room code
[ - - - ]
1. Add Card ...
* Cancel # Save
Show the card
[ 0 0 1 ]
1. Add Card ...
* Cancel # Save
Card Numbs.05410469
[ 0 0 1 ]
1. Add Card ...
Input 001
i
Updated
CONFIGURATIONS
Debug Mode
DMR18S Technical Manual-6-