V-TEK DigiOpen 2Easy DMR18S - Configuration: Work Mode Settings; Work Mode Definition; DT-DJ Mode for Audio Monitors; 32 Apartments Mode

2 EASY
Total four different work modes are available for DMR18S to
accommodate different situations. In standby mode, input #8002
+ 66666666 and press 5 to enter Work Mode setting page
Work Mode set to 0;
The Standard Mode is applied in a small capacity system, which
monitors are under 32 and without BDU unit. Generally dial 01~32 to
call the monitor.
Work Mode set to 0, and ID code set to 0~3.
Input Mode: In standby mode. Input #8001+ Code( 66666666 by
default), then select “ 5 ” item to set the Doorplate Mode, for example
input the code 15 to call the monitor.
Input Mode: In standby mode. Input #8001+ Code ( 66666666 by
default), then select “ 5 ” item to set the Doorplate Mode, for example
input the code 068 to call the monitor.
Work Mode set to 1:
Up to 128 Audio Only Monitors can be connected. The DT-DJ
Mode can assign the address from 001 to 128 without need of BDU
Work Mode set to 1, and ID code set to 0~3
DEFINITION
32 APARTMENTS
DT-DJ MODE FOR AUDIO ONLY MONITORS
* Cancel # Save
(0~3)
[ 0 ]
5. Work Mode [0]
* Cancel # Save
(0~3)
[ 1 ]
5. Work Mode [0]
* Cancel # Save
[ * * * * * *1 1 ]
5. Doorplate Mode [11]
0: *
1: 123
2: ABC
3: -
* Cancel # Save
[ * * * * * 1 1 1 ]
5. Doorplate Mode [111]
0: *
1: 123
2: ABC
3: -
* Cancel # Save
(0~3)
[ 0 ]
1. ID Code [0]
* Cancel # Save
(0~3)
[ 0 ]
1. ID Code [0]
CONFIGURATION
Work Mode
DMR18S Technical Manual-8-
When door station is in
standby, press # key
Input 8002, then Admin
Code 66666666 (default)
Press 5 to enter
Work Mode
[ 8002 ]
Please Input Password
1 2 3
654
7 8 9
#0
*
RF CARD
Press No.
to select
*Back
Setup
1. Language [0]
2. Tone Select [01]
3. Tone Volume [3]
4. Unlock Code [1111]
5. Work Mode [0]
6. Clock ...
7. Setup Code ...
8. About ...
9. Default ...