Vacon 20 - 3.1.5 Changing the EMC protection class from C2 or C3 to C4

monitoring & parameters vacon • 33
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
5
5.7 Digital inputs (Control panel: Menu PAR -> P5)
Code Parameter Min Max Unit Default ID Note
P5.1 I / O control signal 1 0 Varies 1 403
0 = Not used
1 = DI1
2 = DI2
3 = DI3
4 = DI4
5 = DI5
6 = DI6
7 = DIE1
8 = DIE2
9 = DIE3
10 = DIE4
11 = DIE5
12 = DIE6
P5.2 I / O control signal 2 0 Varies 2 404 See 5.1
P5.3 Reverse 0 Varies 0 412 See 5.1
P5.4 Ext. fault Close 0 Varies 6 405 See 5.1
P5.5 Ext. fault Open 0 Varies 0 406 See 5.1
P5.6 Fault reset 0 Varies 3 414 See 5.1
P5.7 Run enable 0 Varies 0 407 See 5.1
P5.8 Preset speed B0 0 Varies 4 419 See 5.1
P5.9 Preset speed B1 0 Varies 5 420 See 5.1
P5.10 Preset speed B2 0 Varies 0 421 See 5.1
P5.11
Ramp time 2 selec-
tion
0 Varies 0 408 See 5.1
P5.12
Motor potentiome-
ter up
0 Varies 0 418 See 5.1
P5.13
Motor potentiome-
ter down
0 Varies 0 417 See 5.1
P5.14
Remote control
place 2
0 Varies 0 425
Activates control place 2
See 5.1
P5.15
Remote control
plece freq refer-
ence 2
0 Varies 0 343
Activates control place 2
See parameter 5.1
P5.16 PID setpoint 2 0 Varies 0 1047
Activates reference 2
See 5.1
Table 10: Digital inputs