Vaisala CARBOCAP GMW90 Series - Other Commands; Enable Advanced Serial Commands; Reset Transmitter

User's Guide _______________________________________________________________________
60 ___________________________________________________________________ M211659EN-C
Other Commands
Enable Advanced Serial Commands
Use the PASS command to enable the advanced serial commands.
PASS [passcode]<cr>
where
passcode
=
Passcode to enable advanced commands is 9000.
Example:
>pass 9000
Reset Transmitter
Use the RESET command to reset the transmitter.
RESET<cr>
Example:
>reset
Resetting
GMW95R / 1.1.28.5849 / XM90
>