Vaisala PTB330TS - 1-Point Adjustment (LCP1); Figure 21 Inside of Open Barometer

Chapter 4 ______________________________________________________________ Maintenance
VAISALA_______________________________________________________________________ 47
0705-091
Figure 21 Inside of Open Barometer
1-Point Adjustment (LCP1)
The LCP1 command performs linear correction for barometer
module/module P1. Use the command LCP1
- to activate or deactivate the linear adjustment function
- to enter new linear offset and offset/gain pressure corrections to the
transmitter
- to edit existing linear offset and offset/gain pressure corrections.
Numbers refer to Figure 21 on page 47:
1 = Adjustment button with indicator LED
2 = Power supply module (not included in PTB330TS)
3 = Power supply mode selections (do not change)
4 = Service port (RS-232)
5 = Module 1/Module 3 connectors
6 = User port (wired to the M12 connector)
7 = Module 2/Module 4 connectors