Vaisala PTB330TS - Measurement Commands; Intv

User's Guide ______________________________________________________________________
68 ___________________________________________________________________M210983EN-A
Measurement Commands
INTV
Use the command INTV to view or set the outputting interval for the
RUN mode.
INTV [xxx yyy]
Examples:
>intv
Output interval: 1 s
>
>intv 10 s
Output interval : 10 s
>
R
Enter the R command to start the continuous output of measurements.
This command starts a temporary RUN mode. The output format can be
adjusted with the FORM command and the output interval can be
changed with the INTV command.
where
xxx = Output inverval (0 ... 255). 0: the fastest possible output rate.
yyy = Unit (s, min, h or d)