9. Supplied with the fire are short and long
lengths of self adhesive foam seal. Take the
short length, peal off the adhesive backing
and stick it to the underside of the hotbox
(See figure 14).
10. Supplied with the fire is a spacing frame.
This is made up of three separate pieces, a
top and two sides. The three pieces are
identified in figure 15.
11. The sides have a stepped top face. These
must be located on the inside the top piece
(See point 1 of figure 16). The tabs on the top
piece must locate on the inside of the side
pieces (See point 2 of figure 16). Secure the
two side pieces to the top piece using two self
tapping screws supplied. Locate the
screws from inside the ‘U’ channel.
Page 22
© Baxi Heating U.K. Limited 2010.
Figure 16. Spacer frame assembly
Figure 15. Assembling the spacer frame
Figure 14. Fitting the foam seal to
the base of the hotbox.
INSTALLER GUIDE
To Next Page
Loading...
