12. FASCIA INSTALLATION
12.1 Fitting the fascia.
1. Unpack the fascia. Carefully
lift the fascia. Place the fascia
against the fireplace front
surface so that the four hooked
brackets at the back of the
fascia are directly above the
four retaining brackets of the
hotbox. There are two at the
top of the hotbox and two to
the side of the burner
assembly. Do not lift the fascia
too high as the bottom of the
fascia will foul against the
control knob. Lower the fascia
unit making sure that the
retaining hooks locate fully into
the brackets on the hotbox
(See figure 26).
12.2 Fitting the heat baffle.
Supplied with the fire is a heat baffle. This baffle must be fitted to the underside of the
spillage hood.
1. Fit the fascia as in section 12.1 above.
2. Secure the baffle to the underside of the spillage hood using the two screws
supplied (See figure 27).
3. Secure the baffle to the fascia using the two screws supplied. The centre hole does
not require a screw (See figure 27).
Page 28
© Baxi Heating U.K. Limited 2010.
Figure 27. Fascia heat baffle location
Figure 26. Fascia location
INSTALLER GUIDE
To Next Page
Loading...
