INSTALLER’S GUIDE
Page 30
Figure 33. Front Coal Location
Figure 32. Ceramic Base Location
12 CERAMIC COALS INSTALLATION
1. Place the ceramic base coal
in the burner compartment.
The bottom rear face of the
coal should rest on the angled
ledges at the back of the
burner compartment. The
bottom front edges of the coal
base should locate against the
left and right hand side
brackets. (See figure 32).
(Installer - Note that the small round holes in
the burner plaques that will be covered by the
base coal are not gas burner ports. They are
simply a consequence of the plaque
manufacturing process).
2. Place the left-hand ceramic front coal in
position in front of the base coal (See figure
33).
3. Place the right hand ceramic front coal in
position in front of the base coal. This should
overlap the left-hand coal. Push the two sides
together to minimise the gap. (See figure 33).
4. There will be a gap between the rear of the
front coals and the front of the base coal. (See
figure 33).
To Next Page
