INSTALLER’S GUIDE
Page 49
16.15 To Remove the Appliance from the Fireplace
1. Remove the burner unit - See section 16.6.
If the fire retention is as method 1 (See section 8.1 of installation instructions), remove
the screws.
If the fire retention is as method 2 (See section 8.2 of installation instructions), slacken
the hexagonal adjusters on the cable retainers and unscrew the thumbscrews to release
the cables.
2. Refit as described in the relevant installation sections. Make sure gas soundness,
sealing, spillage test and performance are satisfactory.
To Next Page
