VARI❋LITE - VL2200 SERIES SPOT LUMINAIRE USER’S MANUAL
20 22-May-01 02.9673.0001 A
Floor Mounting the Luminaire
The luminaire enclosure is sufficient to stabilize the luminaire in a floor installation,
provided that the mounting surface is flat and sturdy.
Connecting Data and Power
A maximum of 32 luminaires may be connected in any one DMX data link.
Note: This maximum limit applies to the luminaire "daisy chain" only. Your system
or console may require fewer luminaires on a single data link path. Consult your
console documentation for more information.
To connect power and data:
1. Connect data cable from console to first luminaire in chain at DATA IN
connector.
2. If required, connect additional data cables from DATA THRU connectors to
DATA IN connectors of remaining luminaires in link.
3. At last luminaire in link, install terminator at DATA THRU connector.
(Luminaire(s) and other devices on the same DMX chain may not function
properly without termination.)
4. Connect AC Input Cable connector to power input source.
5. Dress AC input and data cables and secure them so that they will not
interfere with luminaire head and yoke movement.
Data In
from console
Term inat io n
Data Thru Data Thru
To Next Page
Loading...
