VARI❋LITE - VL2200 SERIES SPOT LUMINAIRE USER’S MANUAL
72 22-May-01 02.9673.0001 A
Choose Sequence Mode:
MSEQ will replay the cues from the master luminaire.
ISEQ will play the cues from each individual luminaire, if any. In ISEQ, if the
number of cues is different, it will only play as many as each luminaire has stored.
The follow time is taken from the master luminaire.
1. Press [Menu].
2. Press [Up] / [Down] arrows until Cue appears. Press [Enter].
3. Press [Up] / [Down] arrows until SEQ appears. Press [Enter].
4. Press [Up] / [Down] arrows to toggle between ISEQ and MSEQ. Press
[Enter] to select mode.
To make a sequence AutoPlay at power up:
1. Press [Menu].
2. Press [Up] / [Down] arrows until Cue appears. Press [Enter].
3. Press [Up] / [Down] arrows until Auto appears. Press [Enter].
4. Use [Up] / [Down] arrows to toggle between OFF (the default) and ON.
Press [Enter] to select the mode.
To store cues from a console:
1. Clear memory by deleting cues or sequence, if required.
2. Recall cue at the console.
3. From Cue menu, set FLTM, then at Stor store cue. If each luminaire has
separate data then store each cue into each luminaire. The sequence mode to
use in this case would be ISEQ.
To Next Page
Loading...
