Setting the navigator
The second digit on the left flashes.
Press the BIKE or TPC button to change this digit.
Press the SET button to confirm the entry.
Once all the digits have been set, confirm the entry
by pressing the SET button.
The response“Set OK” appears on the display.
The settings menu closes.
The VDO M5 returns to function mode.
Once the navigator function appears on the display,
press and hold the BIKE button.
Navigator RESET appears on the display.
If you continue to hold down the BIKE button,
the navigator is reset to zero.
Resetting the navigator to zero
The navigator can be reset to zero any number of desired
times during a trip.
How to reset the navigator:
Press the BIKE button to display the navigator function.
To Next Page
Loading...
