Chapter 5 Basic user instructions
4.2 Remote control operation instructions
4.2.1 Open the battery compartment on the back of the remote control,
make sure the battery effective contact
4.2.2 Please aim remote control to the sensor area of LVP615S, if
there is obstacle between them, LVP615S may not receive
command.
4.2.3 To make sure remote control has a good performance. If found
improper operation, please replace new battery immediately.
4.3.3 Batteries shall not be exposed to, such as sunlight, fire or
the like overheated environment.
After LVP615S boot, it enters the operation status of last shut-down including
signal switching status, PIP/POP (or Text overlay) status and mosaic status.
Among them, PIP/PBP( or text overlay) status and mosaic status can only
realize relative functions and cannot do other operation. Other relative
operations are available under signal switching status. We illustrate the
common operations as below.
To Next Page
Loading...
