5.4 Other basic user operation
5.4.1 Brightness selection
（
Brt+
，
Brt-
）
LVP615S supports 64 level or 100 level brightness selection.
According to“8.5 bright level” selection ， adjustment range has two
kinds：0~64 or 0-100. Factory default is 0-64。To make sure of full
gray scale of output image, it always set as 64（0-100 default value is
50） ！
Reduce LVP615S output brightness，the lowest
is 0.
Increase LVP615S output brightness, the highest
is 64 or 100.
5.4.2 VGA input auto adjustment (Auto)
When LVP615S is in one key switch status and current valid
input signal is VGA, press button to adjust VGA input signal
sampling parameters. Then the VGA output image can be clear and
full.
This operation is normally performed when a new VGA source
is connected. Auto adjustment time is depend on the signal status.
To Next Page
