This option is used to remove trembles, which might happen when
inputs are CVBS/S-Video/HDMI/SDI signals interlace signals (e.g.:
1080i) and used as PIP.
Operation is as below:
Enter “8.4 De-Interlace”, rotate knob to select “On”, press “OK” button
to make setting active.
6.8.5 Brightness Level
0 is minimum brightness, 64 is default standard
brightness.
Allow higher brightness value: 0 is minimum and 50 is
default value.
According to different demands, user can select relative “Bright Level”.
“8.8 Device Reset” will not change the parameter of “bright level”. When
multiple units doing cascading splice, all units must be same “bright level”.
Operation is as below:
Enter “8.5 Bright Level”, rotate knob to select “0-64” or “0-100”, and press “OK”
button to confirm the setup.
6.8.6 DVI hotplug
“DVI hot plug signal” is sent by processor to graphic card or other signal source
devices, as a gist to let the signal source device whether outputs DVI signal
source or not. A few PC when use some software play video on extended
desktop, the “hot plug signal” to the device may cause the player out of order
on extended desktop. If this happens, please enter setup menu “8.6 DVI
Hotplug” to turn this function off.
To Next Page
Loading...
