57
58
3.4 Setup for STICK (MMA) welding
WARNING
Before connecting the work clamp to the work and
inserting the electrode in the electrode holder make
sure the mains power supply is switched off.
CAUTION
CAUTION
Remove any packaging material prior to use. Do not
block the air vents at the front or rear of the Welding
Power Source.
Loose welding terminal connections can cause
overheating and result in the male plug being fused
in the bayonet terminal.
For Alkaline Electrode,connect the electrode holder to the positive welding termimal
Electrode,please connect the electrode holder to the negative welding termimal and
manufacturer. Welding current flows from the Power Source via heavy duty bayonet type
terminals. It is essential, however, that the male plug is inserted and turned securely to
achieve a sound electrical connection. Select STICK mode with the process selection
control.
a n d c o n n e c t t h e w o r k l e a d t o t h e n e g a t i v e w e l d i n g t e r m i n a l , w h i l e f o r t h e A c i d
connect the work lead to the positve welding terminal.If in doubt consult the electrode
Operation
Operation
Arg./Gas (TIG/WIG)
power supply
power supply
power supply
Electrode Holder
Electrode Holder
Earth Clamp
Earth Clamp
Earth Clamp
TIG Torch
DC TIG SERIES EQUIPMENTDC TIG SERIES EQUIPMENT
To Next Page
Loading...
