To Next PageTo Next PageWhat to do if my Vector Welding System has no welding output but the power indicator is lit and the fan is working?
If your Vector Welding System turns on, the power indicator is lit, and the fan is running, but there's no welding output, the control board may be broken, so you should replace it. Another possible cause is damage to the first inverter circuit, which would also require replacement.
Why is my Vector Welding System not turning on, with neither the fan nor the power indicator lighting up?
If your Vector Welding System doesn't turn on, and neither the fan nor the power indicator light up, it could be due to several reasons. First, ensure the power cable is correctly connected; if not, connect it properly. The power cable itself might be broken, requiring repair or replacement. Also, the power switch could be damaged, necessitating its replacement. Another possibility is that the power indicator light is broken, or there are other problems. Finally, the power board might be broken, requiring replacement.
General| Frequency | 50/60 Hz |
|---|---|
| Output Current Range | 20-200A |
| No-load Voltage | 56V |
| Efficiency | 85% |
| Insulation Class | F |
| Protection Class | IP21S |
| Welding Method | MMA (Manual Metal Arc) |
| Input Voltage | 220V |
| Duty Cycle | 60% |
