EMR
3
Setup and Operation Manual Related Manuals
2
Entering the C&C Mode requires that a seal-protected wire jumper or switch in the Display Head be changed.
Changes in this mode must be accordance with local W&M authority requirements. In the C&C Mode you:
• Enter the meter input type and calibrate the meter,
• Enter product descriptions,
• Enter calibration and temperature compensation parameters,
• Configure system I/O devices,
• Enter the OEM message,
• Select between coefficient of expansion or density as a method of temperature compensation for product
delivery.
• Enable price changing in the delivery state (if allowed),
• Enable system security code to limit unauthorized access to delivery setups,
• Select and modify display formats, operating labels, and print labels, and
• Perform a reboot with or without resetting setup parameters to their factory default positions.
Related Manuals
577013-758 EMR
3
Installation Guide
577013-823 EMR
3
Operator Quick Help Card
Safety Symbols
The following safety symbols are used in this manual to alert you to important safety hazards and precautions.
EXPLOSIVE
Fuels and their vapors are extremely
explosive if ignited.
FLAMMABLE
Fuels and their vapors are extremely
flammable.
ELECTRICITY
High voltage exists in, and is supplied
to, the device. A potential shock haz-
ard exists.
READ ALL RELATED MANUALS
Knowledge of all related procedures
before you begin work is important.
Read and understand all manuals
thoroughly. If you do not understand
a procedure, ask someone who does.
To Next Page
Loading...
Need help?
General
