Vega MINITRAC 31 User Manual

45
6Setupwiththedisplayandadjustmentmodule
MINITRAC 31 • Foundation Fieldbus
41782-EN-211203
parameters to ensure the optimum adjustment of the display. The
procedureisdescribedinthefollowing.
This menu item enables the setting of the requested national lan-
guage.
In delivery status, the sensor is set to the ordered national language.
Ifnolanguageispreset,youwillbeaskedduringsetup.
With this parameter you can change the indication of the display.
Youcanchooseifthedisplayshouldshowtheactualpulserate,the
electronics temperature or the percentage value.
Youcanchoosewhetherthedisplayshouldshowthecurrentpulse
rate, the electronics temperature, the process value or the output
signal.
6.4.3 Diagnostics
In this menu item, you can enquire the status of your sensor. In normal
operation, the sensor displays the message " OK". In case of fault,
youwillndthecorrespondingfaultcodehere.
The peak value function holds the max. and min. values during opera-
tion.
•
Pulserates-min./max.
•
Temperature-min./max./actually
Here you can retrieve the adjustment value of the sensor. This is the
percentagevalueofthedierenceofthemin.andmax.adjustment
points(DeltaI).Thevalueisanindicationforthereliabilityandnon-
repeadability of the measurement.
Thehigherthedierencebetweenthetwoadjustmentpoints,
thehigherthedierentialvalue(DeltaI)andthemorereliablethe
measurement.ADeltaIvaluebelow10%isanindicationforacritical
measurement.
Menu language
Displayed value
Device status
Peak value indicator
Adjustment data

Vega MINITRAC 31 Specifications

General

Brand	Vega
Model	MINITRAC 31
Category	Accessories
Language	English