Vega VEGAPULS 67 - Software Update; How to Proceed if a Repair Is Necessary

70
9 Diagnosis, asset management and service
VEGAPULS 67 • Probus PA
36533-EN-170405
If you saved the parameter settings during the rst setup of the sen-
sor, you can transfer them to the replacement electronics module. A
fresh setup is then not necessary.
9.6 Software update
The following components are required to update the instrument
software:
•
Instrument
•
Voltage supply
•
Interface adapter VEGACONNECT
•
PC with PACTware
•
Current instrument software as le
You can nd the current instrument software as well as detailed
information on the procedure in the download area of our homepage:
www.vega.com.
Caution:
Instruments with approvals can be bound to certain software versions.
Therefore make sure that the approval is still eective after a software
update is carried out.
You can nd detailed information in the download area at
www.vega.com.
9.7 How to proceed if a repair is necessary
You can nd an instrument return form as well as detailed informa-
tion about the procedure in the download area of our homepage:
www.vega.com.
By doing this you help us carry out the repair quickly and without hav-
ing to call back for needed information.
If a repair is necessary, please proceed as follows:
•
Print and ll out one form per instrument
•
Clean the instrument and pack it damage-proof
•
Attach the completed form and, if need be, also a safety data
sheet outside on the packaging
•
Please contact the agency serving you to get the address for
the return shipment. You can nd the agency on our home page
www.vega.com.