SAFETY
Safety - 10
General Safety Procedures
for Ventrac Power Units, Attachments, & Accessories
• Ensure the attachment or accessory is locked or fastened securely to the power unit before operating.
• Ensure that all bystanders are clear of the power unit and the attachment before operating. Stop the ma-
chine if someone enters your work area.
• Always be alert to what is happening around you, but do not lose focus on the task you are performing.
Always look in the direction the machine is moving.
• Look behind and down before backing up to be sure of a clear path.
• If you hit an object, stop and inspect the machine. Make any necessary repairs before operating the ma-
chine again.
• Stop operation immediately at any sign of equipment failure. An unusual noise can be a warning of equipment
failure or a sign that maintenance is required. Make any necessary repairs before operating the machine again.
• If equipped with a high/low range feature, never shift between high and low range while on a slope. Always
move the machine to level ground and engage the parking brake before shifting range.
• Do not leave the machine unattended while it is running.
• Always park the machine on level ground.
• Always shut o the engine when connecting the attachment drive belt to the power unit.
• Never leave the operator’s station without lowering the attachment to the ground, engaging the parking
brake, shutting o the engine, and removing the ignition key. Make sure all moving parts have come to a
complete stop before dismounting.
• Never leave the machine unattended without lowering the attachment to the ground, engaging the park-
ing brake, shutting o the engine, and removing the ignition key.
• Only operate in well-lit conditions.
• Do not operate when there is a risk of lightning.
• Never direct the discharge of any attachment in the direction of people, buildings, animals, vehicles, or
other objects of value.
• Never discharge material against a wall or obstruction. The material may ricochet back toward the operator.
• Use extra caution when approaching blind corners, shrubs, trees, or other objects that may obscure your vi-
sion.
• Do not run the engine in a building without adequate ventilation.
• Do not touch the engine or the muer while the engine is running or immediately after stopping the en-
gine. These areas may be hot enough to cause a burn.
• Do not change the engine governor settings or over-speed the engine. Operating the engine at excessive
speeds may increase the hazard of personal injury.
• To reduce the hazard of re, keep the battery compartment, engine, and muer areas free of grass, leaves,
excessive grease, and other ammable materials.
• Clear the working area of objects that might be hit or thrown from the machine.
https://www.tractormanualpdf.info/
To Next Page
Loading...
